If you are not redirected in 5 seconds click the logo above |
Decal Instructions
Dry
Method:
The Quick and easy way to apply these decals is to peel back the paper backer
just enough to expose about a quarter inch of the decal. Make sure the
window is clean. Position the decal and lightly touch the exposed portion
to the glass. You'll need a squeegee or similar with a smooth even edge.
Using even pressure and starting where the decal is tacked to the
glass, start working the decal onto the window, sliding the squeegee, while
peeling back the paper backer. Try to do this in one movement. If
you stop and lift the squeegee, you may get a thin line of bubbles. Peel
of the transfer mask and your done. The draw back to this method is, once
it's down, it's down for good.
Wet Method:
Start with a clean window. Usually you would use a solution called Slip,
but you can make your own out of dish soap and water. One good drop of
dish soap in 1/2 gallon of water will do it. The dish soap (even though
its a small amount) will make the water slippery and allow bubbles to be forced
out from under the decal. Peel the paper backer off of the decal and get
the adhesive good and wet with the solution. Place the decal onto the
window and squeegee from the center out. You should be able to look
through the window and see if there are any bubbles. If there is, work
them out with the squeegee. Let the decal sit an hour or so to let the
solution under the decal dry up a bit. Then peel off the transfer mask and
your done. If you try to peel the transfer off to soon, you might pull the
whole decal off. The nice thing about this method is that you can
reposition the decal (before it's dry) if you don't like the position or
accidentally put the decal on upside down (crazier things have happened).